Hello everyone and sorry for my English.
I have a problem to be solved urgently.
I have a cnc bought (used) with DeskCNC and PC control (Windowx xp). For a month, everything went well, but now suddenly the machine stops (at some point of the process), and the x, y, z is zero (just about where it stops the spindle).
The machine moves but very rigid. Then I turn off and turn on and that's fine, but if part machining after some crashes again. I also formatted the computer and reinstalled the software but the problem remains. I hope I can help you understand the problem.
Results 1 to 2 of 2
-
12-07-2016, 11:29 AM #1
Registered
- Join Date
- Dec 2016
- Posts
- 1
Desk cnc crashes. Pressing problem.
-
12-07-2016, 10:19 PM #2
Member
- Join Date
- Apr 2004
- Posts
- 5737
Re: Desk cnc crashes. Pressing problem.
I can't say I do understand the problem, but have you tried contacting DeskCNC DeskCNC Home page and asking them about it? The site is still up, but I'm not sure how active they are. Still, it couldn't hurt to ask.
Reply With QuoteSimilar Threads
-
Pressing reset changes G54 values to zero.
By kmuller in forum FanucReplies: 1Last Post: 12-24-2014, 04:06 AM -
8025 Problem: Controller "crashes" and now X,Y,Z Axis off ...
By ferrumdg in forum Fagor AutomationReplies: 7Last Post: 06-11-2013, 06:39 AM -
pressing problems.
By fmcbrandon in forum Maintenance DIY DiscussionReplies: 0Last Post: 05-27-2011, 10:15 PM -
Desk Engraver problem
By Fran in forum CNC (Mill / Lathe) Control Software (NC)Replies: 7Last Post: 05-10-2003, 07:55 PM
Tags for this Thread
Posting Permissions
