Hello everyone.


sorry my English is not perfect.
I propose my problem the function searches board with utensil.
When searching with axis and y + y - everything is going ok as expected with
(Feedrate F Metric Units 50 min 8:40) Search with low speed, looking on the screen to
top left I read the gcode Mill G1 G15 G17 G40 G21 G90 G94 G54 G4 as I
shown in the picture.

While when I run the search with axis x + x - start feedrate problems of
in research to speed suit (feedrate F Units 50 min 371.78) reads in the picture, but
doing other tests also Metric Units min 600.00.
Always looking at the screen at the top left I read this time the gcode Mill G15
G0 G17 G40 G21 G90 G94 G54 G4. the research is so fast
given that the law G0 code.

long weeks this problem, doing research on the web, no one talks about this problem.
these photos of mach3 you notice that not referenced and you see the axis in red, not having homing sensors.
I explain that I'm doing this mach3 working with laptop.
Mach3 version. Mach3 - R3.043.066 - buy 2015
Big-Tex setter tool 3.4 - buy 2015