Hi Gerry,
I'm a newbie about cnc controller , I have buy a UC300ETH, but I have a dubt also the manual installation of CNCdrive not more clear about. I need use UC300 with my four drivers by china type DM542 and 4 motors nema 23 for a 4 axis mill. Can you explain also with drawing schematic , how to make a system that work fine ? I need of buy also breackout card for each axis for conect my drivers ? what type of breackout I need andwhere must they be connected on uc300 output connector pins ?
Whitch can be a right configuration with my drivers and motors?
thanks