[Pplug]

Hi,
I have an LTT ILS III laser sitting in school and the x axis started cutting rough. I took the carnage apart and one of the bearing wheels was gouged. I'm looking for a replacement part. The bearings are good, I just need the plastic wheel for the outside of the bearings. The wheel measures 16mm X 6mm with a hole of 8mm.

I have not contacted LTT yet,but I was hoping somebody had a ready source for these parts.

Thanks,

Chris Corwin

[mickanoday]

Hi,
I have an LTT ILS III laser sitting in school and the x axis started cutting rough. I took the carnage apart and one of the bearing wheels was gouged. I'm looking for a replacement part. The bearings are good, I just need the plastic wheel for the outside of the bearings. The wheel measures 16mm X 6mm with a hole of 8mm.

I have not contacted LTT yet,but I was hoping somebody had a ready source for these parts.

Thanks,

Chris Corwin

dear Chris,
sorry for disturbiing you,
i am going probably to buy an LTT ILS3,not a new one, and i would like to know if it is a good choice or not, this one have only 150 hours so i think it is ok, but what about the soft, technical and others,
thank's a lot to take a few time for me, Mickael , France

[dcorwin822]

Unfortunately Chris passed away back in 2016. I hope you have good luck with your machine!

[Shelby5041]

hi mickmonday

do you still have the ILS3 laser?

i just bought a used ILS-3NM and hard to find any troubleshooting info