I have just acquired an A50 which on power up displays the following fault codes : 1031, 1001, 701. Can anyone point me in the right direction ?
I have just acquired an A50 which on power up displays the following fault codes : 1031, 1001, 701. Can anyone point me in the right direction ?
Hi Clive
Are you sure its an A50 ?????????
1001 Spindle Monitor Off When Commanded
This indicates that there is a voltage on the spindle motor when the CNC is not
commanding any spindle movement.
1031 Spindle Motor Fan Overload
701 Fan overheat The fan on top of the cabinet for the control unit is overheated
Hi Darren,
It is in fact a Tornado 80. (misled by seller !)
I have looked at the Spindle amplifier module. The fan is going round but looks pretty dirty so will take it out and clean it. Same with the fan on the spindle motor.
Clive
Manuals are ready I did email you please call me