[lancecollins]

Hello Guys,

Need some help! We have a Charmilles Robofil 310 and when we boot the machine it would only show the blue/gray screen with the F1, F2, F3 options. After a few attempts, then we received a message on the screen E0B P00?.

We were installing USB Emulator ad unable to get it going at the moment so we were going to come back to I later. After reconnecting the floppy drive, that is the message we keep getting. I have tried to reboot with the USB hooked back up disconnected the 3.5 Floppy and still the same issue.

Any help would be greatly appreciated?

Lance

[bytor]

I'll chime in, but straight up, I've never met this control. At first blush, it looks like software corruption. How old is this control? How does it boot up - floppy, hard drive ?? Was this issue happening before you installed the floppy emulator?
On the few floppy emulators I've met, they have jumpers on them for the IRQ/address. What are yours set to? Did the emulator come with any installation instructions?