585,758 active members*
4,459 visitors online*
Register for free
Login

Thread: Newbie needs help

Results 1 to 2 of 2
  1. 01-09-2017, 05:12 PM #1
    rs200
    rs200 is offline Registered
    Join Date
    Nov 2016
    Posts
    2

    Newbie needs help

    Hi guys, I am located in Hofmeyr in the eastern cape. I have built a cnc table and am using Mach 3 and sheetcam.Is there a program available to take a scanned image, edit it and convert to DXF?
    Thanks.
    Reply With Quote Reply With Quote
  2. 02-20-2017, 06:51 AM #2
    melvinbruce
    melvinbruce is offline Registered
    Join Date
    Mar 2016
    Posts
    43

    Re: Newbie needs help

    Hi you can try inkscape. it is free
    https://www.youtube.com/watch?v=gdWWYZ27U-k
    then look at this video it shows you how to.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Newbie
    By kokomojo in forum Community Club House
    Replies: 0
    Last Post: 01-28-2014, 06:38 PM
  2. NEWBIE NEEDS A LITTLE HELP
    By breathe in forum DIY CNC Router Table Machines
    Replies: 3
    Last Post: 07-12-2010, 10:43 AM
  3. newbie need help
    By az786again in forum Commercial CNC Wood Routers
    Replies: 1
    Last Post: 05-13-2010, 09:21 AM
  4. Newbie in NZ
    By DAYG in forum Community Club House
    Replies: 0
    Last Post: 05-06-2010, 07:40 AM
  5. Newbie needs help!!!
    By bwhite505 in forum DIY CNC Router Table Machines
    Replies: 5
    Last Post: 04-25-2010, 02:13 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules