585,733 active members*
5,010 visitors online*
Register for free
Login

Thread: R2e4

Results 1 to 3 of 3
  1. 02-17-2007, 05:13 AM #1
    steve ohalloran
    steve ohalloran is offline Registered
    Join Date
    Jun 2006
    Posts
    7

    R2e4

    Before i get to my new problem, I would like to thank everyone for all the help that I receaved from this forum. Now for the new problem, When I try to enable the spindle nothing happens. I checked all fuses, keypad test, 1st. event log and reseated boards. what next. Steve
    Reply With Quote Reply With Quote
  2. 02-17-2007, 06:08 AM #2
    machintek
    machintek is offline Moderator
    Join Date
    Nov 2004
    Posts
    3028
    Is Your way oil tank full?
    Air turned on?
    Are you holding the other switch to high or low while turning the spindle enable on?

    George
    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Reply With Quote Reply With Quote
  3. 02-18-2007, 08:02 AM #3
    steve ohalloran
    steve ohalloran is offline Registered
    Join Date
    Jun 2006
    Posts
    7
    George, it was the way oil. Thanks SOH
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Bridgeport R2E4
    By steve ohalloran in forum Bridgeport / Hardinge Mills
    Replies: 11
    Last Post: 06-21-2010, 09:11 AM
  2. bridgeport 9 r2e4
    By reedmiles in forum Bridgeport / Hardinge Mills
    Replies: 4
    Last Post: 06-23-2007, 02:07 AM
  3. r2e4 drives
    By najnielkp in forum Bridgeport / Hardinge Mills
    Replies: 0
    Last Post: 10-23-2006, 02:45 PM
  4. R2E4 Help
    By jeep534 in forum Bridgeport / Hardinge Mills
    Replies: 2
    Last Post: 10-14-2006, 05:45 PM
  5. bridgeport 9 r2e4
    By reedmiles in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 0
    Last Post: 12-30-2005, 03:06 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules