Re: ENCO RF45 Clone CNC Conversion - LinuxCNC
Good Job Kurt;
I also would enjoy the Linux discussion you mentioned above since I plan on using linux (maybe pathpilot)t on My RF45 revamp! I have the electronics and motors for a DMM Tech setup using large Nema 34 model 92 motors. Should provide plenty of torque for the little machine. I'm going to build a computer for the system using the components and a power supply inside a hoffman enclosure. I'm planning to load only linux and not use windows at all but again, I'm completely new with this setup. I would like to get away from Mach and go to a more simple format!
Michael.
Where are you located in SC? I'm close to the Inman area!
Thanks again for posting Guys!
Bill
billyjack
Helicopter def. = Bunch of spare parts flying in close formation! USAF 1974 ;>)