Hi,
i have a new to me Mazak VTC20B -96 with Mazatrol M plus control.
Servos: HA83NC-S
Drives: MDS-B-V1-10 and MDS-B-V2-1010 (dont know which one controls what)
occasionally my X axis servo starts humming when motion stops, it will go away after 10-15 secs or instantly if i move the axis again. Load % goes up when humming occours.
Normally at idle my X load is 4-6% higher than the Y axis.
Any advise on what to check?
Thanks
Gustav