Reading of problems of the flat bed of the tormach stand, and poor coolant drainage, I am considering putting spacers under the left side of the machine, then lowering the left side of the stand to bring the machine back to level.
Should I use tapered spacers under the machine to avoid tweaking the casting, or can I get away with a couple washers?
The recommended slope for sewage plumbing is 1/8 to 1/4" slope per 12 run. Since floating away sewage is not my goal, a bit more slope may be better, My thought is giving it 1/2" for the 18inch span of the machine base.
Any recommendations as to amount of slope?
Thanks.