Anyone done this, regrind the inner taper portion of a cutter grinder sleeve?
( where the cutter collet contacts the sleeve )
Maybe some type of set-up with a Dumore grinder on the lathe?
Wold prefer to farm it out to someone with more experience with this type of thing.
Cost for a new sleeve is 690.00 from GTI but unsure about fit with
the existing index head, which is why i tend more towards just regrinding.
Was quoted 4000 for a complere index head, not worth it.
Can get near new SO's on eBay for under that.
Or new Kuhlmann SU-2 for 5500 rom GTI.