http://https://youtu.be/BSqfchqx1c8
I had been wanting to clean up my wires and I hate zip ties, so here was my solution.
http://https://youtu.be/BSqfchqx1c8
I had been wanting to clean up my wires and I hate zip ties, so here was my solution.
bad link
https://youtu.be/BSqfchqx1c8
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Don't have time to watch it right now, but have seen similar videos for cleaning up wiring in PC's. A little advice. Turn your camera sideways when shooting video.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I figured you would catch that. This was video number two, and my buddy had mentioned the same thing. So I'm trying to keep it landscape from here on out.