I have been trying to figure out the easiest way to manipulate a drawing to match what I am trying to accomplish. I needed to shorten & widen my detail for the part I need to run. I have only drawings that were previously done by someone with much more experience than I & the extent of my Alphacam training was the intro class & they do not cover turning centers for cnc routers anyhow from what I was told by the instructor. Any help is greatly appreciated & thank you in advance!
Thread: Turning Center Help?
Results 1 to 2 of 2
-
02-14-2017, 07:54 PM #1
Registered
- Join Date
- Apr 2014
- Posts
- 2
Turning Center Help?
-
03-12-2017, 09:13 PM #2
Member
- Join Date
- Apr 2015
- Posts
- 327
Re: Turning Center Help?
Let me know on a [email protected]. Not sure what exactly you need.
Alphacam post and VBA macros, Autodesk HSM post.
www.cadcam-softcz.cz
Reply With QuoteSimilar Threads
-
WTB TAKISAWA TURNING CENTER
By psient in forum Want To Buy...Need help!Replies: 1Last Post: 09-07-2011, 09:45 AM -
Off-Center Turning
By Perfect Circle in forum MetalWork DiscussionReplies: 3Last Post: 07-16-2011, 11:22 PM -
Okuma LB-10 Turning Center
By Dwayne Foy in forum OkumaReplies: 3Last Post: 11-06-2009, 02:53 PM -
Turning Center G40 G41 and G42
By jorgehrr in forum G-Code ProgramingReplies: 16Last Post: 04-14-2007, 04:48 AM -
Looking for help with Okuma turning center.
By shawn45223 in forum CNC (Mill / Lathe) Control Software (NC)Replies: 3Last Post: 02-08-2007, 12:06 AM
Tags for this Thread
Posting Permissions
