Hi guys I hope someone can shed some light on a problem I am having with my new Hypertherm Powermax 45xp. It doesn't matter if I am gouging or cutting, The arc just goes out mid way thru a run, its very intermittent. There is no water coming out of the nozzle just dry air. The ground is clean, the compressor is full. I have a moisture/water trap halfway down my airline to catch anything. The pressure at the moisture trap is good. The consumables are new. It is driving me up the wall ! I bought the machine because its a great piece of kit BUT until I get the wrinkle ironed out its a boat anchor.
Can someone shed some light on what I am doing wrong please
Regards Badger