Hi,
I've a Deckel Maho DMU 50 eVolution machine with Heidenhain controller. In this machine as soon I switch on I'm getting Z83 - Motor encoder warning error message. When I press Clear button this alarm will reset. I make Hydraulic on . When I try to reference the axes I'm getting E60 - Axis ready signal is low error message and I can't move any of the axes. I checked the Interface cards and found Ready( green LED) and SH2(red LED) are lit on each axes interface card. I checked Door interlock signals are ok. Please let me know how to check the other enable signals and how to solve this issue.
Thanks,
Sandeep