[c1awson]

Morning all,

i have eave recently had an alarm C27 and B27 alarms. I am aware that possibly the positions have moved maybe when power down so there was a difference between known and actual position.

I managed to accept these New positions, I did this by putting the machine to demo mode, MC80,then MC98 =3. I then accepted these C and B positions , but I also accepted H1 which is the tool magazine position.

this has put the magazine out position by half a tool.

Does anybody know the correct parameter to reset the zero position or the ZP offset for this axis, I don't want to change all the positions for each pocket.

Regards

Paul

[c1awson]

Apologies,

My machine is a Deckel Maho DMU100

Regards