584,805 active members*
5,350 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Viper Servo drives > I desperately need some help setting up a viper250 servo driver
Results 1 to 2 of 2
  1. #1
    Join Date
    May 2005
    Posts
    13

    I desperately need some help setting up a viper250 servo driver

    I just got the board and I'm in way over my head. I have the manual for the Viper 200 downloaded from the website but I'm to dumb to figure it out. My first question is were should I put the jumpers? The manual has diagram showing 5 pairs of jumper pins my board only has 3 pair.
    Is there a way to load the settings from one of the other Viper 200 boards on the machine, which seem to be working?
    Any help would be greatly appreciated.

  2. #2
    Join Date
    Feb 2008
    Posts
    42

    Re: I desperately need some help setting up a viper250 servo driver

    Quote Originally Posted by skypilot View Post
    I just got the board and I'm in way over my head. I have the manual for the Viper 200 downloaded from the website but I'm to dumb to figure it out. My first question is were should I put the jumpers? The manual has diagram showing 5 pairs of jumper pins my board only has 3 pair.
    Is there a way to load the settings from one of the other Viper 200 boards on the machine, which seem to be working?
    Any help would be greatly appreciated.
    I know this is an old posting, but certainly a valid question.

    I too own a 250 which I will be dropping into a retrofit. Here is Larry's response to the question:

    The bottom 2 are step multiplier same as V200. the top one isn't used.
    The drive only has 1 bank.( not 3 like older V200F)

    Just an FYI for those who will be purchasing this product in the future.

    Mark
    Need a Supermax YCM-40 Mill manual? Download the PDF here (replace _ with .):
    http://www.istonline.ca/download/supermax-ycm-40.pdf

Similar Threads

  1. Yaskawa Servo driver CPCR-MR01C Driver problem
    By pvpatel in forum Benchtop Machines
    Replies: 0
    Last Post: 04-04-2016, 09:25 AM
  2. stepper driver using h-bridge to analog servo driver
    By aztec in forum Servo Motors / Drives
    Replies: 2
    Last Post: 02-07-2016, 06:24 PM
  3. Replies: 6
    Last Post: 11-20-2015, 07:11 PM
  4. Replies: 0
    Last Post: 02-07-2014, 01:29 AM
  5. Servo motor specs. and driver setting questions.
    By southernexplore in forum Servo Motors / Drives
    Replies: 1
    Last Post: 08-04-2006, 01:21 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •