Dear Friends,
Facing a strange problem with YAM make turning m/c with 12 turret post,

M/C is running ok without turret indexing.
Turret is indexing perfectly in JOg mode.
In MDI / Auto mode as Turret command execuated , start cycle light goes OFF & after than Auto cycle can be run only power OFF/ON.
No any alam displayed , dignosis bit 7 of 712 get high & after that no auto operation possible.
Is iit possible to read the ladder of Fanuc 3T.

M/C SPECIFACTION:
Control Fanuc 3T
M/c MAKE : CK-1-3T
M/C MODEL: A02B-00580B501
SR. NO. 71-0784
YAM NO. M-7022
12 TOOL TURRET

Here under the timers & counter data,
TIMERS VALUE
208 10
209 111100
210 1100100
211 100
212 101000
213 1010
214 1010000
215 0
216 1010
217 1000

COUNTER
160 10010
161 0

PRESET
168 1
169 0

PC EPROM D46F-HYD-12

If any body can help, I will be thankful.
Regards,

Rajesh