584,866 active members*
5,114 visitors online*
Register for free
Login
IndustryArena Forum > CNC Plasma, EDM / Waterjet Machines > PlasmaCam > HELP! PlasmaCAM Doesn't Finish Initializing
Results 1 to 3 of 3
  1. #1
    Join Date
    May 2013
    Posts
    4

    HELP! PlasmaCAM Doesn't Finish Initializing

    When I initialize, the Z goes up, X and Y go to the top left corner as they are supposed to, then the motors go "twerk", "twerk", "twerk", continually until I turn the controller off. On the monitor, the window that indicates that it's still initializing remains. Here's a video link: https://youtu.be/xN1ZH9__1hc

    My machine was working fine until today, it is grounded to the earth, and I have installed the latest updates. Just in case it's pertinent, I also have Design Edge.

  2. #2
    Join Date
    Sep 2014
    Posts
    112

    Re: HELP! PlasmaCAM Doesn't Finish Initializing

    Give those fellas in tech support a call. They'll get you going in no time. It looks like you have an older DHC machine, instead of the DHC2. Checking the wires on the z might be a good idea. I am curious, does the z move up and down when you use the keys on the CB.

    When you call plasmacam's tech, ask them about the the DHC2 upgrade kit that you can get for your older dhc system. It basically will make your into a new machine for a fraction of the cost.

    Good Luck Pal!

    JAG

  3. #3
    Join Date
    Jun 2018
    Posts
    4
    Have you tried checking your microswitches? These are the ones that act as limit switches when the machine initializes and senses the home position. They are standard, cheap and easy to replace (located on the gantry & on/under the Y-axis motor). I’ve had to blow them clean from time to time with compressed air when cutting motion got glitchy. I have one of the older machines, purchased in 2003.

Similar Threads

  1. Mazatrol T32 initializing
    By terra103 in forum Mazak, Mitsubishi, Mazatrol
    Replies: 16
    Last Post: 07-13-2023, 06:33 PM
  2. mach3 (?) - machine doesn’t finish the cut as it suppos to
    By thedemri in forum Mach Software (ArtSoft software)
    Replies: 2
    Last Post: 01-21-2013, 01:43 AM
  3. Z axis trouble while initializing?
    By Bradsky in forum PlasmaCam
    Replies: 1
    Last Post: 12-20-2011, 07:01 PM
  4. Battery change and initializing position _ NL series
    By aidenkim in forum Mori Seiki lathes
    Replies: 2
    Last Post: 08-26-2011, 02:28 PM
  5. Re-initializing Controller Software
    By Geof in forum Haas Mills
    Replies: 2
    Last Post: 03-18-2007, 06:54 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •