508,275 active members
3,132 visitors online
Register for free
Login
IndustryArena Forum > CNC Electronics > Hobbycnc (Products) > All axis move one direction
Results 1 to 2 of 2
  1. #1

    Unhappy All axis move one direction

    I have stepper motor and breakout board , i had purchase it from china
    then when i connect it with PC , and mach3

    tried many time to move direction, but no way, it just move to one way

    i change every wire and double check it
    when i try to move motor to other direction
    i changed breakout board
    i changed PC ( For change parallel /port )
    i changed mach3 program

    tried every thing can , but no thing change

    Pls any one have any ideas

    be note am new in this

  2. #2
    Registered
    Join Date
    Jun 2005
    Posts
    1375

    Re: All axis move one direction

    Check the direction output, does it change from a Low to High or High to Low when you switch directions. You probably do not have the Port and Pin set correct for the direction output pin for each axis.

    Russ

Similar Threads

  1. Replies: 1
    Last Post: 01-31-2015, 04:29 AM
  2. How to setup JOG control to move 2 axis with each direction key
    By MickPaul in forum Mach Wizards, Macros, & Addons
    Replies: 2
    Last Post: 06-29-2013, 12:06 PM
  3. Replies: 7
    Last Post: 01-22-2013, 07:14 PM
  4. x axis will only move 1 direction
    By brent48 in forum Stepper Motors / Drives
    Replies: 1
    Last Post: 11-09-2010, 06:25 PM
  5. x axis will only move one direction
    By CATCH22 in forum Mach Mill
    Replies: 2
    Last Post: 12-17-2007, 03:53 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •