I am new to the CNC world and doing lots of testing with trial and errors.
I purchase a few bits with better luck on others.
I like to cut flat bottom lettering and noticed some bits are far from flat. Using a 1/8" bit in a dewalt 611 at a medium speed I had best results so far on a amanda 46260 1/8 bit.
Using wood such as hard maple or walnut. I noticed that by amanda website this 46260 is not designed for wood.
With that said I like to get some bits for cutting flat bottom letters and lines to get the smoothest cut possible.
Any recommendations on bits to use, or not use.
Thanks