[FranschTech]

I am in need of some know how!
No sure where to start, the controller on cnc mill Quantum S1000D with Anilam 6000M control has a problem it starts up and go to the menu when I select any of the three choices it goes in and freezes up, I can not go back or do anything and the word halted is in the command bar. Any ideas what I should do will be greatly appreciated.
I have posted a video of the startup.


Sent from my iPhone using Tapatalk

[FranschTech]

I am in need of some know how!
No sure where to start, the controller on cnc mill Quantum S1000D with Anilam 6000M control has a problem it starts up and go to the menu when I select any of the three choices it goes in and freezes up, I can not go back or do anything and the word halted is in the command bar. Any ideas what I should do will be greatly appreciated.
I have posted a video of the startup.


Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

[ridgeprecision]

has the machine been running recently? Normally, when you get to the screen pictured, you have to reset the servo... ( estop out then press servo reset) then press the f-key for home to home the machine, then you will get the manual screen, and can go into the programs... dave

[FranschTech]

Thanks Dave
I have been away and working on other projects,
I tried to reset the servo but no response, I have found that the drives have a power fault light on and SH2 lamp on each drive. Any ideas how to go about this?Attachment 369018


Sent from my iPhone using Tapatalk

[ridgeprecision]

Check to see if you have 24vdc for the e-stop and limit switch circuit... then check all limit switches, for a stuck switch or bad wire connection... dave

[crclark]

I know this is a year old but did you ever find a fix or help? A friend of mine is having the same problem.

Thanks

[philtrueman1]

Did you solve your servo problems? I have just fixed my inverter

[philtrueman1]

Thanks Dave
I have been away and working on other projects,
I tried to reset the servo but no response, I have found that the drives have a power fault light on and SH2 lamp on each drive. Any ideas how to go about this?Attachment 369018


Sent from my iPhone using Tapatalk

Check out my repair here it fixed my machine on Practical machinist
Search for Anilam 6000M Inverter Repair