I hoping to find someone that is using Gibbscam with an Okuma MYW lathe. I have purchased the post from Gibbs, but I am running into lots of issues. Currently Gibbs is backed up in the post department and hasn't gotten back to me. I went through this on another Okuma post and it required literally 19 post modifications. Unfortunately this base post appears to be much the same as that one. Long and short of it is that every new program is a red light festival.

Im not looking for a free post, my hope is that someone on here has a proven post that I can direct Gibbs to pull from their library and use as a baseline.

Thank you in advance!