[rui_sjm1]

¿lo solucionaste?

Acceleration is too high, is missing steps, and sptes per mm may be worg because you reset controller.

[GaGuy]

Hello I'm having the same problem... my x,y show 1000mm when I turn the machine on it slams into the side of the machine and doesn't stop.

[rui_sjm1]

Hello I'm having the same problem... my x,y show 1000mm when I turn the machine on it slams into the side of the machine and doesn't stop.

See if end stops is working, if you want you can desativate home function in vendor settings on ruida controllers

[RCaffin]

Well, for a start, your machine should be in eStop when you turn it on. You should put it in eStop before you turn it off.

Cheers
Roger

[ACCTEK-Barry]

i have the same idea as rui-sjm1
our conpany use Ruida conrtrol system for our machine too
The most likely situation you encounter is that the step parameter of the motor changes due to resetting the system
You can find the software manual on the official website of Ruida, modify the parameters according to the manual, I hope it will help you

[belizabeth4]

Here is a quick video of what I'm talking about.

https://www.youtube.com/watch?v=tUXjW9yKHCs

It wasn't making that noise before.

did anyone ever get a fix for this problem and I'm just missing it? Are corrupt parameter files the culprit? I have exactly the same problem, but I am really kinda stuck because I inherited my laser and I have 0 files in the way of a backup. Also, the laser was new when I got it, but it had set for 6 years. Oddly everything is current tech in the way of controllers etc. (Ruida 6442G) It isn't a US machine (that I can tell) the scan tag led me to Orion Motors --- which is Omtech. So I probably have the equivalent of a 50W CO2 Omtech. I just can't find the definitive setup files etc. Any help is much appreciated!! Thanks