584,814 active members*
5,222 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Cincinnati CNC > What Connector Do I Need?
Results 1 to 5 of 5
  1. #1
    Join Date
    Aug 2015
    Posts
    100

    What Connector Do I Need?

    Hi everyone!!

    I am looking to add a cooler to the door of my 01 Arrow 2 1250C. I want to tap into the fuse block next to the computer in the cabinet as it has some open fuses. They are a weird flat bullet type connector. I cannot seem to find it in the parts manual or online. I was hoping one of you guru's on here would know the connector. Thank you for your help!

  2. #2
    Join Date
    Dec 2013
    Posts
    5717

    Re: What Connector Do I Need?

    They are called Ferrule Connectors

    Ferrules Terminals | Mouser

    The crimping tool is a bit pricy. search "Ferrule Connector crimp tool"

  3. #3
    Join Date
    Dec 2006
    Posts
    584

    Re: What Connector Do I Need?

    You should not connect the unit to the machine power. You should connect it to another outside power outlet to eliminate the interference of the unit turning on and off sending voltage spikes through the machine and control.
    This is a problem that our customers have encountered when adding additional coolers!

    MIKE CNC Machine Services INC | Cincinnati Milacron MachinesCNC Machine Services

  4. #4
    Join Date
    Aug 2015
    Posts
    100

    Re: What Connector Do I Need?

    You think I will have a problem with just adding 4 fans? This is all it is. 2 fans on the inside and 2 on the outside. It is not a compressor or oil cooler. Just an air heat exchanger. I didnt think fans would make much of a problem as there should be fans inside the cabinet anyways. Also, what are those empty fuses for then?

  5. #5
    Join Date
    Mar 2008
    Posts
    283

    Re: What Connector Do I Need?

    Jordan, Using the wiring diagram stamped on the back plate of the machine x9120xxxxyyyy; look around page # 4; it will show you that F7 & F8 were for work lights that must have been removed at some time and were rated for 5 amps. Greg W. @ 859-534-4750

Similar Threads

  1. OP connector sanyo denki servo PV drive - looking for connector
    By gm276 in forum Want To Buy...Need help!
    Replies: 2
    Last Post: 12-15-2018, 07:39 PM
  2. What is this connector?
    By vickson in forum Controller Cards
    Replies: 2
    Last Post: 06-21-2012, 09:26 AM
  3. JP5 connector
    By CAROLIVAR in forum Dynomotion/Kflop/Kanalog
    Replies: 8
    Last Post: 12-26-2011, 09:32 AM
  4. connector???
    By xray34 in forum HURCO
    Replies: 4
    Last Post: 07-29-2011, 05:50 PM
  5. Anyone know the name of this connector?
    By h3ndrix in forum DNC Problems and Solutions
    Replies: 5
    Last Post: 09-19-2010, 09:21 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •