Hi!
I have MATSUURA ES450H, FANUC 18i.
The problem:
After the power on, nc, drives, hydrostation switched and ready for action.
But I can not to move any axis or zeroid these. No errors or alarm message in the screen.
If I unblock NC (set K07.D0 INTERLOCK NEGLECT = 1), then can move, zero axis e t c.
But auto mode is inpossible (MDI, AUTO mode).
i understand then there is blocking circus in NC sequence.
Any advice? What is can be?
All the drives are ready ("0" in LED). Spindle is ready ("--" in LED). No errors, all fuses are in good condition.
If I return INTERLOCK NEGLECT = 0, the machine is "died".
All proposal will be accepted!