It's an 1100 Series 3, I had to relocate the connector on the right side of the electronics cabinet, and at that position it's impossible to plug it in from the front door, I need to always go on the right side of the enclosure and pull up the window to connect it.
Terry, I was thinking to do something like you did, but on the top side of the door to avoid as much coolant as possible, probably they suggested to remove the entire buttons/switches plate because the buttons and connectors ware not waterproof .
Did you had any problem in time, if you keep the probe always in the enclosure ? and not in it's case
That Millfast product looks good, I would mount that on the top side of the door and also the probe .. very nice ideea with the braket.. that's something I would doo soon
Thank you for the idea !
smokediver576, Dan is someone at Tormach ? a little longer cable will be better, but the original one is also ok, not too tight when plugged in on the right side of the cabinet, but also not loos at all, just a little tighten