Hello
I use Aspire 8.5 to milling out this,look at the picture and you will see 5 slight mark after 3d Finish,these slight mark should not be there.
I wonder,What can be wrong ?
Aspire software,Settings in Mach3 or CNC Router machine
Hello
I use Aspire 8.5 to milling out this,look at the picture and you will see 5 slight mark after 3d Finish,these slight mark should not be there.
I wonder,What can be wrong ?
Aspire software,Settings in Mach3 or CNC Router machine
This looks like cutter deflection caused by the tool moving in opposite directions. Reduce your depth of cut on the finish pass and this effect will be reduced. This is a typical example of 'conventional' vs 'climb' cutting. There isn't anything wrong with your software or hardware, it's machining technique.