Hi, I have had the machine for three months, was doing a bit of levelling of the wasteboard. Stopped to change settings in CNCUSB software and went to move the spindle but nothing. Checked the Control box and it was as if it was turned off. No Freq read out, no fan, etc. Tried on/off, changed wall sockets, still nothing. Did a bit of troubleshooting but that didn't get me very far. I concluded (rightly or wrongly) that the power supply must have died so organised replacement of the same part number and spec. When it arrived I installed it and connected the cables one at a time. Turned the box on and still nothing, so that was a bummer!
Any of you knowledgable gentleman out there help me any further please?

Mick.