[fordav11]

just to add, if you only have a hard copy you can first punch the parameters as-is then edit the file with any text editor just changing the 9000-series numbers to what your machine needs. then save the file and read it back into the machine through the serial port.
note this works for ANY Fanuc control except the very latest 31i/32i etc

[memoryman]

fordav11, to my knowledge the param 8000 trick only works on the 15A.

[fordav11]

Yes, I'm aware the 8000 PWE parameter is specific to the 15-series.
I'm specifically referring to punching parameters, edit file adding options, and then read parameters back into machine.

[jamsari]

sorry, do you have all the parameters of FANUC 15. may I ask hardcopy pdf document. I ask for help because I have lost my documents .. please share
sorry thank you for your help

[VIESK7]

Do u still have the secret code?

[Pesekstyle]

Hi, i have a 15T, may i ask for the parameters to. I can`t find the parameters for COUNTER and KEEP RELAY.
Where do i have to input the parameters for Timer (Sub24)?

Tnx, best regards,
Daniel

[Pesekstyle]

hi, i have a 15T model, could you please send me the backup. i wont to compare the parameters and see what i am doing wrong.
Tnx a lot.
Daniel

[dhinakaran]

Hi
I am using fanuc 15M and i cant key in optinoal parameter in ipl mode
Please send me the procedure to key in optional parameters if any one have it

[Mahesh63]

I have a backup of parameters,pitch,etc. for my 15M at work.Maybe you can used those.You transfer them to the machine the same way you transfer programs.And I don't think you need a password.I know I don't.

What is solution ??

[General661]

Hello, I’m having the same problem, We are stuck at the IPL, we lost power to controller when the batteries went dead. Not sure if we need password. Can any one help with this? Thank you.

[memoryman]

You will need a a backup of the NC and PMC parameters as a minimum. Do you have these? You can send an email to me at [email protected]

[Hassanhac]

Dear all!

Recently I had ram parity error (base0) error on this machine. Battery was never changed so memory was cleared and I lost all the parameters! Therefore, I cleared all the memory and I entered again by hand all the parameters. Machine started now without alarm but I cannot enter parameters from 9000-9020, 9100-9139. This parameters are important because number of axes are stored there etc. Now I have number of axes by default: 1, so I can drive only one axe )
I called Fanuc guy and he said that it requires a password for this parameteres. What kind of password?? Where to enter?
Also, on papers I found some timers and I entered them also. What about counter, keeprly, Data table data? Does anyone knows how looks like printout of this additional parameters? What else I have to enter in the machine, what to take care of?
Thank you very much!

I have same problem with my machine
Please send me how to solve it
[email protected]

[memoryman]

email me at [email protected]