Hello guys,
I only made about 7 steel part on my Tormach so far, almost all the parts needed to be machining on the other side, so for setting the origin on the flipped part, I used the only element I could use, a 4mm hole I made from the first setup.
But my problem started when I tried to find the center with the digitizing probe, because it has that "double move" first time quick, than retracts and try again at a slower feed rate. The problem is I couldn't find the a way to set the distance it retracts after findg the margin using the higher feed rate. When it retracts it hits the other side of the hole and I get an error that the probe is already tripped.
To be able to find the center of the hole I manually jog left untill it touched the margin, than moved right to touch the margin, than moved to the middle and made the same for Y axis .. but this is a little slow.
Is there any other way to probe small holes, any setting I can make to eliminate the retract, or make it smaller ?
Thank you.