We're running a GWeike laser now about half an year. All of a sudden the machine does not properly realign the y-axis. Cuts which should be at the same height get a difference of up to 3-4 mm. We did: inspect, clean the belts, the tension looks good, contact of the motor plug looks good. We decreased the speed - until all in vain.
What else can be done? Increase the tension? Exchange motors? (xy to yx)? Software?
Software? Windows 7/64, lasercut 5.3 compatibility applied. The data is normally imported from CorelCAD 2017 file format export as dxf R2000-2002 ASCII.
If you know another good data flow like out of Adobe Illustrator version?, file format version? etc. pls tell us - Thanks