Hey guys,
Running Bobcad V28. The does a lot hole tapping on the Haas VF3-YT50. Material is 304SS. Is it possible to Peck Tap in Bobcad? I don't see an option for it like there is for drilling. I know the Haas is capable of it by turning on setting 133. This makes the spindle orient each time it enters the hole.
Here is a snip of the code: (It's just doing a single depth) Would prefer multiple pecks to clear the hole out of chips.
(TOOL #10 Badger UNC 5/8-11 Hand Tap)
N917 T10 M06
N919 T13
N921 G90 G54 X1.5 Y2.1275 S98 M03
N923 G43 H10 D10 Z1. M08
N925 G00 Z-0.2
N927 G95
N929 G84 G99 X1.5 Y2.1275 Z-1.3506 R-0.3 F0.0909
N931 G80
N933 G94
N935 G00 Z-0.2
N937 Z1.
In the Haas example on Youtube, they are showing multiple tap pecks.
X0 Z-1. ;
X0 Z-1.5 ;
X0 Z-2. ;
X0 Z-2.5 ;
Any ideas?
Thank you.