Hi guys

I'm new to the fanuc controller, but have 15 years of experience with Siemens and Heidenhain.
My workplace bought a brand new Robodrill with 21 tool holders.
On both Heidenhain and Siemens you can have e.g. T50 i holder nr.1. and you just call T50, but on the Fanuc I can only call T1-T21?
Is there any way to get about this, because we have a rather comprehensive tool library already setup in MasterCam?

On Heidenhain/Siemens you save the length etc. with the tool number.
On Fanuc you save it under a H-number.
Do you save the tools used along with a tool offset list with every program, if so how is this done?

Regards Jacob