Hi i have an axyz series 6010 router that i would like to be able to use mastercam on. Currently using tool path. Does anyone know what type of post processor i would need to be able to do this?
Results 1 to 2 of 2
-
05-29-2017, 12:17 AM #1
Registered
- Join Date
- May 2017
- Posts
- 1
need help- post processor for mastercam needed for my axyz series 6010
-
06-19-2017, 06:42 PM #2
Registered
- Join Date
- Jun 2017
- Posts
- 2
Re: need help- post processor for mastercam needed for my axyz series 6010
Unfortunately, if you are using ToolPath, you are using an AMC controller in the table. That being said, ToolPath is the proprietary software that runs that table. An electronic retrofit would bring you to the A2MC which can be controlled by many different types of CAD/CAM softwares. This kit can be ordered (and installed) from AXYZ or you can try to undertake this adventure yourself and replace whats needed to be able to run say Mach 3 or something similar.
Reply With QuoteSimilar Threads
-
Mastercam x5 post processor for Multicam 3000 series
By DRtyler in forum Post Processors for MCReplies: 1Last Post: 07-23-2015, 01:54 PM -
Mastercam to Galil Post processor needed
By bbutcher85710 in forum Post Processors for MCReplies: 6Last Post: 01-11-2015, 03:40 PM -
Post processor for mastercam 8 needed
By Tashadra in forum Mach MillReplies: 0Last Post: 12-03-2012, 11:15 PM -
AXYZ 6010 router problems
By fgwilson99 in forum DNC Problems and SolutionsReplies: 6Last Post: 09-20-2012, 10:43 AM -
Post processor needed for Mastercam
By giardbusa in forum MastercamReplies: 1Last Post: 11-28-2011, 04:51 PM
Tags for this Thread
Posting Permissions
