Hi,
Im new into 4 axis milling. Would you please tell me how to go about machining the "red profile" as well as the fillet on the edges.Thank you in advance.
Hi,
Im new into 4 axis milling. Would you please tell me how to go about machining the "red profile" as well as the fillet on the edges.Thank you in advance.
Havent tried it on a 4 axis like that, but you can try the swarf
My second homebuilt cnc machine cnczone.com/forums/norwegian_club_house/123977-ombygget_cnc_-_gecko_540_a.html
Me, I would probably stick the rod into a centred ER32 collet on the mill table and do a simple milling.
I would use a snug fit pin throught the holes for rotary alignment.
Cheers
Roger
You have 100mm ER32 collets?
Oh yeah, along with a bridge to sell.
There were no dimensions on the jpg as far as I could see.
Hum - IF 100 mm diameter, then two solid angle brackets at right angles and some solid clamps.
I reckon I sometimes spend more time figuring out the jigging than doing the machining. It happens that way.
Cheers
Roger
PDF?
That came up black on my screen. Oh well.
Cheers
Roger