I recently rewired my limit switches to free up a pin for an emergency stop button and auto zeroing and now each time I engage a limit switch it doesn't allow me to reset the switch automatically and I have to go back into Config - Ports and Pins in Mach 3 to disable them each time before I can reset my cnc machine. I was previously able to do so via a warning screen that showed me that a limit switch was triggered and asked me if I wanted to reset the switch automatically. I'm not sure why this is happening now and don't want to waste a lot of time trying to figure this out myself. Is there anyone that has had a similar problem or that can give me a hand with solving this problem for me. Thanks in advance for any assistance that you can provide.