[Kalvin]

Hi guys, been a while since I've been on here.

I have a question about ball screws.

I have an X3 that I converted a few years back with an CNCfusion kit.

I'm looking for info on how the ball screws are assembled or maybe a break down image.

I'm trying to figure out what the set screws in the sides of the ball screw end are holding? There are 2 at 90 degress to each other. Do they hold that white plastic scraper ring in?

https://drive.google.com/file/d/1-9r...ew?usp=sharing

Cheers,

[CitizenOfDreams]

Those holes are for lubrication. The set screws just plug the holes.

[cncuser1]

The empty holes are oiling.
The holes with setscrews....the setscrews hold the white plastic wipers( which keep debris out of the insides)