How can I mill through the workspace without damaging vacuum table?
How can I mill through the workspace without damaging vacuum table?
You typically use a spoilboard on your table and the vacuum flows through the spoilboard. So you can cut slightly into the spoilboard.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)