I can't seem to figure out if there is a way to change the machine starting point in Aspire. Would appreciate some help!!
Thanks,
Mike
I can't seem to figure out if there is a way to change the machine starting point in Aspire. Would appreciate some help!!
Thanks,
Mike
The toolpath start, or where the machine moves to before it starts cutting, which is the Home Position in Aspire.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)