Especially for lathe use.
On the product page the wiring diagram belongs to the C10 board and it is really hard to tell which wire goes where.
Especially for lathe use.
On the product page the wiring diagram belongs to the C10 board and it is really hard to tell which wire goes where.
I guess the answer is NO.
OK, below is a part from the C10 wiring schematic.
Say, I'm wiring the X axis driver:
Pin 2 from the BOB goes to PUL +
Pin 3 from the BOB goes to DIR +
COM from the BOB is splitting to 3 and each goes to ENA -, DIR -, PUL -
Am I correct?
Suat,
Yes, you can use that wiring diagram.
Arturo Duncan
Welcome to CNC4PC