I am not able to configure in the right way the G-post for Mazak Integrex 1060.
Could someone tell me if it is available a download site to get one copy of it??
I would use it under Pro/Wildfire 2.0 or 3.0.
Thanks in advance
Massud
I am not able to configure in the right way the G-post for Mazak Integrex 1060.
Could someone tell me if it is available a download site to get one copy of it??
I would use it under Pro/Wildfire 2.0 or 3.0.
Thanks in advance
Massud
i am not aware of any free posts out there, but if you find one i would like to know too.
If you have a active maintenance agreement with PTC you can download a few free Postprocessors from their websites here: http://www.ptc.com/cs/cs_23/howto/ncgp4903/ncgp4903.htm
Requires a password though.
Theese are often more easy to modify rather than writing one from scratch.
Other than that I think you will have to pay up to get one custom made, if you dont find a kind sould that has the same setup as you.
Best regards, Jonas
Also need post processor file for Mazak 1060 and Alphacam v7
Anybody have this file please?
Thanks in advance.