[zookisisko]

Hello everyone,I bought it CNC Machine Fadal VMC15 model 914, Mechanically is good condition, but Electrical is have some problems.
Machine can started, but monitor does not want to play the image....I think the problem in the Computer Numeric Control.
The did not give me any books with my Machine .Because the machine is old.
Now, is there anyone who wants to help me with a book or instructions about her ?

[warrenb]

First off check all the connectors.

Did you hold in the "start" button above the power button?

Can you see any evidence that there is power to the monitor? Do you see little lines or bright spots that would show power is getting to the monitor?

Check the monitor card is plugged in all the way. Pull it out and clean the connectors.

[zookisisko]

Yes, I start the button, but i will check the cables again if all are OK..

[Welder2022]

On the upper left of the control there is a "video" switch for the monitor. Is it on?
Also you have to hold down the green start button for 3-4 seconds for the control to power on.

[zookisisko]

Green Button CNC Power from Back of Machine i hold and my machine started, and on the monitor Video is ON, but i don't understand the button upper left what function is doing.....
Now my servicer review the Graphic Card from the Electronics.. I'm trying to repair her factory control on this machine with my service technician, so I would be grateful that you know how to help me around to start together.

[Mhook]

Hi
After you turn machine control with green button
All of red led on controller must be blinking (5)
If not please check com & +12 -12 vdc on powersupply

These pdfs maybe help you

http://compumachine.com/Support/DL-Fadal.htm
And download
Troubleshooting.pdf