[poolrod2]

Hi everyone, this horse has been beat a few times before, so any help would be great. I just picked this up and would love to hear it sing. My question is basically, 4 wires red black white and green going into a 5 pin plug/connector. The Sherline will connect to the plugs inside the D&M and will run direct from the computer software,the board in the machining
center casing has been bypassed I think and the center is just for show maybe.
All I need is the pins numbers for the 4 wires to be soldered to the 5 pin connectors to plug the PC
cables into the back connectors on the D&M for the motor and steppers.The wires on the steppers are red green black and white.
Per diagram, I have red on 6, black and white on 2+5, no yellow or orange wire, just a green one left. Would it go on orange or yellow pin?.
I would hate to tear my -A- axis cable apart from the PC to see the configuration.

[poolrod2]

Any help would be great on the green wire.

[CS900]

I'd take the case apart and see where the 5th wire goes. My original guess was for shielding in the stepper cable, but doesn't look like your cable has a shield....

[poolrod2]

Thank you.

[poolrod2]

The steppers are from Oriental motors, not Sherline.