hello. I am new to the cnc world, I use Bobcad and I think I have drawn and Embossed them correctly. When I load it into Mastercam it is backwards. I rotated the display ( i know that is stupid) but is cuts the same. I run the simulation in bobcad and it looks right. I cut it and it cuts same as the display. like it is cutting the letters from the bottom. I have cut things before and they were ok, I have worked on my soft limits and not sure what I have done. Any help would be greatly appreciated.
Thank you so very much.
I have looked at other post and found that maybe my X and Y on the machine are not
right. I have built my machine so this is very possible.