[motordude]

Hello all,
I am trying to modify SprutCAM standard Fanuc postprocessor downloadable from their website. I have managed to modify some, but need some help to get further.
What I have is the following:

N7 S4000 M3
N8 G00 G43 H7 X-124.01 Y107.407 Z30. A0.
N9 Z13.
N10 M8
N11 G01 G94 Z10. F200
N12 X-125.876 Y107.521

I want to move the red bold Z coordinate to the line below:

N7 S4000 M3
N8 G00 G43 H7 X-124.01 Y107.407 . A0.
N9 G00 Z30.
N10 Z13.
N11 M8
N12 G01 G94 Z10. F200
N13 X-125.876 Y107.521

Any help is much appreciated!

Best regards
John

[tkgb]

Sprutcam 7 came with many postprocessors,not very good ones but lots of them

Maybe you can find one that is close to what you need.

[motordude]

Sprutcam 7 came with many postprocessors,not very good ones but lots of them

Maybe you can find one that is close to what you need.

Thanks for your response! I figured it out, all OK now.