[pimpbike]

Hey guys can someone guide me on how to properly wire this together? I've followed the wiring diagram suggested but no luck. I get proper LED output when trying to jog an axis on the bob (I'm using Mach 3) I wired up other stepper drivers and bobs before but this one has me stumped thx

[jahnj0584]

VCC is your 9-40V input. GRD is just that.

A + B are your motor coil pairs.

The three - pins all get daisy chained together and sent to ground
then enable, step, and dir go to your board to whatever pin you set those too. Very simple drivers to set up.

[newmeat]

I have similar frustrations and just hope that a friendly crowd awaits.
Being a newbie to cnc doesn't help and Ive gone the DIY route on steroids.
Built myself a router and find i cant wire the thing, internet doesnt help
because "it aint idiot proof bud."
If you can help......HY-JMK5 BOB to tb6600 please please idiot proof wiring
Diagram from PSU to BOB to drivers xy and z......