1988 Lagunmatic 110
LinuxCNC 2.7.0
Mesa 5i25/7i77
I have retrofitted this mill to Mesa/LinuxCNC from the old Dynapath Delta20 controls.
I am wondering what to do about the knee. When I got the mill there was no motor for the knee but there was a power cord ran to that general location so I assume there used to be one on it but not sure. There is no handwheel, just a shaft sticking out. Do these knees typically have a servo on them? Or just a little gearmotor? or handwheel? Is there typically knee position feedback to the controller?