Hi,

I am completely new in this area of expertise and have a question.

I have looked through different recommendations of which programs to use for creating a sketch and then creating the cutting path (again completely new at this so the terminology might be off). So far I have settled on either Sketchup or Fusion 360. Since I have no experience in either 3d modelling or Cam I guess I might as well earn it proper and go the deep route i.e. Fusion360.

My question is then, is this a good choice? Will it work with the MicroMill, should I start with a simpler tool and so on?

Best Regards
Jan Svensson eagerly awaiting my MicroMill